718
edits
Changes
From Pumping Station One
mLine 17:
Line 17: + + + + + + + + + + + + + + +
→things: add mill table cover
** can be affixed to cabinets / tool carts / shelves to show little charts of when they were last thoroughly organized
** can be affixed to cabinets / tool carts / shelves to show little charts of when they were last thoroughly organized
** idea is to provide a decentralized, low-overhead means of coordinating contents organization / cleanup
** idea is to provide a decentralized, low-overhead means of coordinating contents organization / cleanup
* modular table covers for the bridgeport
** modules
*** idea is to have them be in sections of 4-10" so they can accommodate the vice moving, &c
**** make multiple sizes, so they can be rearranged?
*** will need at least two special ones to fit snugly against vice sides, which aren't square
*** should have magnets in, so they stick to the table
*** blocks that fit (loosely?) into the t-slots, so they register easily
** manufacture
*** will have to laser-cut, to get the contours for the vice-hugging sections right
*** engrave holes for magnets & mark out t-slot block positions
*** screw / glue / staple t-slot blocks down?
**** top surface should be flat, so would need to countersink screws carefully
** material
*** maso or mdf would be easiest
*** plastic (hdpe?) for wear / oil resistence?
