Difference between revisions of "Supermax 25x2 Drum Sander"
Jump to navigation
Jump to search
Rebrendler (talk | contribs) m |
Zacksasnow (talk | contribs) |
||
Line 31: | Line 31: | ||
|Danger committee | |Danger committee | ||
|6/23/2017 | |6/23/2017 | ||
+ | |- | ||
+ | |Zack Sasnow | ||
+ | |Jason Shanfield | ||
+ | |8/27/17 | ||
|} | |} | ||
Revision as of 13:24, 28 August 2017
Owner/Loaner | PS:One |
---|---|
Serial Number | ? |
Make/Model | 25x2 |
Usability | yes |
Contact | Eric Beauchamp |
Where | Wood Shop |
Authorization Needed | yes |
Hackable | no |
Estimated Value | $2700 |
Host Area | Wood Shop |
Qualified Member | Trained By | Date |
---|---|---|
Eric Beauchamp | Danger committee | 6/23/2017 |
Ralph Brendler | Danger committee | 6/23/2017 |
Paul van Lake | Danger committee | 6/23/2017 |
Zack Sasnow | Jason Shanfield | 8/27/17 |
Notes
- For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper.
- Use a belt cleaner occasionally to refresh the sandpaper
Safety
This sander features overload detection. If the machine detects too high a load, it will automatically slow down the feed. This saves wear and tear on the machine, but may cause burning of the workpiece if you cut too aggressively.
- The height adjustment on this machine is VERY aggressive. A full turn will raise the table by more than 2mm (a typical cut should be < .5mm). PLEASE USE A MAXIMUM OF 1/8 TURN OF THE HEIGHT WHEEL PER PASS!
- Make your first cuts with a very slow speed (10 or less). Once you are sure the load is OK you can gradually increase the speed on subsequent passes.
- When overload detection kicks in, a red light next to the speed control will turn on. IF YOU SEE THIS LIGHT, PLEASE REDUCE YOUR DEPTH OF CUT AND/OR FEED RATE!
- Like all of our other sanders, sleeves must be above the elbow, and no gloves should be worn. It's pretty easy to get pulled into the rollers.