DoAll Bandsaw
Owner/Loaner | PS:One |
---|---|
Serial Number | 45-55525 |
Make/Model | DoAll 16-2 |
Arrival Date | 9/19/14 |
Usability | yes |
Contact | Dean Anderson |
Where | machine shop |
Authorization Needed | yes |
Hackable | no |
Estimated Value | 900 |
Host Area | {{{hostarea}}} |
This tool requires certification for use.
Specifications
Capacity | 16" from the blade to the column |
Blade Size | 120" blade. Width up to 1". Each width requires a set of hardened steel guides and a holder. See below for the guides we have. |
Blade Speed | approximately 45 to 1600 FPM, continuously variable. |
Power | 240V, 3 phase |
Weight | 1500-2000 pounds |
Mfg. Date | 1955 |
Operating Notes
Change speed range by moving the lever up and to the other side. Only do this when the motor is running and when the variable speed setting is at its lowest speed.
Change the variable speed setting only when the motor is running.
Blades
Installed:
To-Do
Install new blade.
Replace thrust bearings in blade guide.
Blade welder is missing the grinder motor. The welder has not been tested. The 20 amp plug/outlet may not be sufficient.
Maintenance
Description | Frequency | Lubricant | Instructions | History | |
---|---|---|---|---|---|
Gear Box | The manual for model 16-2 (our saw) says to use SAE 10 motor oil. The manual for the 1612 (a slightly newer model) says SAE 20. DoAll support says use SAE 20 motor oil, which is difficult to find. ISO 68 waylube is equivalent to SAE 20 and available from Zengers in Melrose Park. | The drain plug is at the bottom of the gear box. Remove pipe cap and fill to the top of the pipe. Takes about 1 quart. | Changed 10/7/14 with ISO 68. Only about 2 cups of oil were drained, but no sign of a leak. | ||
Reeves drive shaft (oil cup) | 1612: SAE 10 |
Equipment
Item | Description | Supplier | Cost |
---|---|---|---|
Guide thrust bearing | 626ZZ 6x19x6mm (2 required) | ||
Guide holder | Upper and lower holders for 1/8-1/2" width blades ('precision' style); upper and lower holders ('high speed' style) for 3/4 to 1" width blades. | ||
Guide | Sets of 4 hardened steel guides for 1/4, 3/8, 1/2, 3/4. A spacer block for 3/4" may be missing. |
References
List of Currently Certified Users
Qualified Member | Trained By |
---|---|
Dean Anderson | |
Everett Wilson | Dean Anderson |
Ed Bennett | Dean Anderson |