DoAll Bandsaw
From Pumping Station One
This tool is currently broken, please contact the area host for more information. |
Owner/Loaner | PS:One |
---|---|
Make/Model | DoAll 16-2 |
Arrival Date | 9/19/14 |
Usability | soon |
Contact | Dean Anderson |
Authorization Needed | yes |
Hackable | no |
Estimated Value | 900 |
Host Area | {{{hostarea}}} |
This tool requires certification for use.
Specifications
Capacity | 16" from the blade to the column |
Blade Size | 120" blade. Width can be up to 1". Each blade width requires a set of four hardened steel guides. We don't have guides for blades wider than 1/2". |
Blade Speed | approximately 45 to 1600 FPM, continuously variable. |
Power | 240V, 3 phase |
Weight | 1500-2000 pounds |
Mfg. Date | 1955 |
Blades
Installed:
To-Do
Install new blade.
Change oil in transmission.
Replace thrust bearings in blade guide.
Blade welder is missing the grinder motor. The welder has not been tested. The 20 amp plug/outlet may not be sufficient.
Maintenance
Description | Frequency | Lubricant | Instructions | History |
---|---|---|---|---|
Gear Box | manual says 16-2: SAE 10 motor oil, 1612: SAE 20 ; DoAll support says use SAE 20 motor oil | |||
Reeves drive shaft (oil cup) | 1612: SAE 10 |
Equipment
Item | Description | Supplier | Cost |
---|---|---|---|
Guide thrust bearing | 626ZZ 6x19x6mm (2 required) |
References
List of Currently Certified Users
Qualified Member | Trained By |
---|---|
Dean Anderson | |