Difference between revisions of "AlarmLock PDL3000"
Jump to navigation
Jump to search
(adding rules on access control) |
(Adding programming instructions) |
||
Line 22: | Line 22: | ||
== Changing the door code == | == Changing the door code == | ||
+ | |||
+ | Door code logic: eacch allowed code is associated with a user id between the numbers 12 and 50, inclusive. | ||
+ | |||
+ | Currently, User 1: contains the program | ||
+ | |||
+ | === Programming the door === | ||
+ | |||
+ | <code>{MASTER CODE} A</code> | ||
+ | |||
+ | You are now in program mode until you hold a button for 3 seconds. | ||
+ | |||
+ | ==== Adding ==== | ||
+ | |||
+ | <code>A 2 A {User ID} A {CODE} *</code> | ||
+ | |||
+ | ==== Deleting ===== | ||
+ | |||
+ | <code>A 2 A {USER ID} *</code> | ||
+ | |||
+ | == Erasing All Programing == | ||
+ | |||
+ | # Remove battery | ||
+ | # Hold down A for 10 seconds (drain the capaciters) | ||
+ | # Reinstall Battery | ||
+ | # withing 5 seconds of hearing 3 beeps, Hold A until it beeps more | ||
+ | # The lock is now reset, the master programming code is now the default. |
Revision as of 23:30, 9 March 2014
Owner/Loaner | PS:One |
---|---|
Serial Number | {{{serial}}} |
Make/Model | PDL3000 |
Arrival Date | {{{arrived}}} |
Usability | yes |
Contact | {{{contact}}} |
Where | Installed on Front Door |
Authorization Needed | yes |
Hackable | yes |
Estimated Value | ~$1000 |
Host Area | {{{hostarea}}} |
Getting an Access Code
In order to get the access code, you should A: be a paying member in good standing with the organization, and B: have your id checked by 2 board members. The best time to get your ID checked is at a general meeting which occur every Tuesday at 8:00pm.
Reprogramming the Lock
The full manual is available at http://www.alarmlock.com/images/pdf/ETPDL_PDL3X00_WI1021C.07_PROG.pdf
Sharing the door code
- Please don't share the door code with non-members
- If you don't have the ability to verify membership status, please don't give out the door code.
Changing the door code
Door code logic: eacch allowed code is associated with a user id between the numbers 12 and 50, inclusive.
Currently, User 1: contains the program
Programming the door
{MASTER CODE} A
You are now in program mode until you hold a button for 3 seconds.
Adding
A 2 A {User ID} A {CODE} *
Deleting =
A 2 A {USER ID} *
Erasing All Programing
- Remove battery
- Hold down A for 10 seconds (drain the capaciters)
- Reinstall Battery
- withing 5 seconds of hearing 3 beeps, Hold A until it beeps more
- The lock is now reset, the master programming code is now the default.