Line 37: |
Line 37: |
| |- | | |- |
| |} | | |} |
| + | |
| + | == Major Components == |
| + | |
| + | <gallery> |
| + | File:doall-bandsaw-power-plug.jpg|The 4-prong, twist-lock power plug; note the band of purple tape |
| + | File:doall-bandsaw-power-cutoff.jpg|The power cutoff switch, in the 'off' position; the power cutoff needs to be in the 'on' position before the machine will turn on |
| + | File:doall-bandsaw-power-control-panel.jpg|The power control panel; note the on button (upper left), off button (upper right), and key switch (bottom; pictured in the upright, locked); the key switch needs to be unlocked (turned to the right) before the on button will turn the machine on |
| + | File:doall-bandsaw-cut-parameter-chart.jpg|The cut parameter chart, listing blade speeds & pitch for different materials & thicknesses |
| + | File:doall-bandsaw-speed-dial.jpg|The blade speed dial, which should be set according to the the proper cut parameters found in the chart |
| + | File:doall-bandsaw-gear-selector-knob.jpg|The gear selector knob, in 'high' gear, for coarse control of the blade speed |
| + | File:doall-bandsaw-speed-selector-wheel.jpg|The speed selector wheel, for fine control of the blade speed |
| + | File:doall-bandsaw-table.jpg|The tilting table, in the horizontal position |
| + | File:doall-bandsaw-table-tilt-lock-wheel.jpg|The table tilt lock wheel, in the 'locked' position'; the table's angle can be changed when the wheel is unlocked, and then fixed again in place |
| + | File:doall-bandsaw-blade-guide.jpg|The blade guide; its height above the table is controlled by the positioning wheels |
| + | File:doall-bandsaw-blade-guide-positioning-wheels.jpg|The blade guide positioning wheels: height adjustment (top) and lock (bottom) |
| + | </gallery> |
| | | |
| == Auth/Use Notes == | | == Auth/Use Notes == |