Domain Admins
586
edits
Changes
Jump to navigation
Jump to search
Line 56:
Line 56: − + − + Line 63:
Line 63: − + − + − + − Requires removing gearbox. See below.+ − + − + − + − + − + − Gearbox oil change. Loosen 2 screws on the left edge of right top cover. Remove top 2 screws on the right side. Loosen bottom 2 screws on the right side cover. Slide top cover towards the center of the saw. Pivot the right cover down. Remove drive belt. Remove gearbox step pulley. Remove 3 bolts holding the gearbox. These are near the ring gear teeth. Remove the gearbox out the top of the saw between the two transverse brackets (long shaft comes out last). Drain/fill bolt is on the side opposite the pinion gear. Consider replacing the gaskets on the gearbox.
→Maintenance
! History
! History
|-
|-
|Hydraulic cylinder
|
|Maintain level at top of oil cup.
|
|
|
|
|
|-
|-
|Gear Box
|Gear Box
|yearly
|
|80W-90 gear oil
|
|Drain and fill with 3 ounces of oil.
|
|2/14 8 oz 85W90
|
|-
|-
|Pivot bar
|
|monthly
|
|General purpose grease
|
|2 Zert fittings. Use grease gun.
|
|
|
|}
|}
== Equipment ==
== Equipment ==