WikiBots
1,397
edits
Changes
Jump to navigation
Jump to search
mLine 37:
Line 37: − + − + − + Line 55:
Line 55: − +
Robot: Cosmetic changes
== Operating Notes ==
== Operating Notes ==
To turn on the saw: 1) Make sure it is plugged in. This saw shares an outlet with the Johnson bandsaw. The plug is a twist-lock. Turn the plug counter-clockwise to remove from the outlet. 2) The big cutoff switch on the left of the machine needs to be in the 'on' position. 3) Turn the key on the front to the right. 4) Push the round black button on the front of the machine.
To turn on the saw: 1) Make sure it is plugged in. This saw shares an outlet with the Johnson bandsaw. The plug is a twist-lock. Turn the plug counter-clockwise to remove from the outlet. 2) The big cutoff switch on the left of the machine needs to be in the 'on' position. 3) Turn the key on the front to the right. 4) Push the round black button on the front of the machine.
Adjust the height of the blade guide to be just above the workpiece. On the back of the saw above the blade are two knobs. The lower knob locks the guide in place. The upper knob adjusts the height of the guide.
Adjust the height of the blade guide to be just above the workpiece. On the back of the saw above the blade are two knobs. The lower knob locks the guide in place. The upper knob adjusts the height of the guide.
Change speed range by moving the lever up and to the other side. Only do this when the motor is running and when the variable speed setting is at its lowest speed.
Change speed range by moving the lever up and to the other side. Only do this when the motor is running and when the variable speed setting is at its lowest speed.
Change the variable speed setting only when the motor is running.
Change the variable speed setting only when the motor is running.
Replace thrust bearings in blade guide.
Replace thrust bearings in blade guide.
Blade welder is missing the grinder motor. The welder has not been tested. The 20 amp plug/outlet may not be sufficient.
Blade welder is missing the grinder motor. The welder has not been tested. The 20 amp plug/outlet may not be sufficient.
== Maintenance ==
== Maintenance ==