Line 1: |
Line 1: |
− | A 15-piece set of ER25 collets, in 1/16" increments, from 1/16" to 5/8" (the full range of the collet size) | + | A set of ER25 tooling. |
| | | |
| {{Template:EquipmentPage | | {{Template:EquipmentPage |
Line 6: |
Line 6: |
| |certification = no | | |certification = no |
| |hackable = no | | |hackable = no |
− | |model = 3900-5235 | + | |model = 3900-5235 (collet set) |
− | |serial = 69053 02866 | + | |serial = 69053 02866 (collet set) |
− | |arrived = 2017-01-02 | + | |arrived = 2018-02-24 |
| |where = [[Bridgeport Knee Mill#In the Large Mill Accessories Cabinet|Large Mill Accessories Cabinet]] | | |where = [[Bridgeport Knee Mill#In the Large Mill Accessories Cabinet|Large Mill Accessories Cabinet]] |
| |doesitwork = yes | | |doesitwork = yes |
| |contact = [[User:mct|McTavish McArdle]] | | |contact = [[User:mct|McTavish McArdle]] |
− | |value = $110 | + | |value = $200 |
− | |image = er25-collet-set.jpg | + | |image = er25-tooling-set.jpg |
| }} | | }} |
| + | |
| + | = Contents = |
| + | This tooling set includes: |
| + | * A 15-piece set of ER25 collets, in 1/16" increments, from 1/16" to 5/8" (the full range of the collet size) |
| + | * Two ER25 collet blocks; for both blocks, the nut is larger than the block diameter, so careful work holding is needed |
| + | ** A square collet block, 35mm across & ~42mm tall |
| + | ** A hex collet block, 35mm across (minor diameter) & ~42mm tall |
| + | * An ER25 collet holder, with an integral R8 taper |
| + | ** ''[Note that the runout on this collet holder is rather horrific, and it will need to be reground before it will be useful]'' |
| + | * An ER25 collet nut spanner (affixed by magnets to the inside top of the box) |
| + | |
| | | |
| [[Category:Loaned Equipment]] | | [[Category:Loaned Equipment]] |