483
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: − + − + − + + − + − + + − − The Forge is currently owned by Adrianna and is on loan to the Hot Metals Area along with the following black smithing equipment: − − Anvil − Standing Vice − Sledge Hammer − − Adrianna (owner) or Tom Judge (Hot metals area host) can certify you. The following will be covered in the certification:+ − − ;How to light and turn off the forge. − * To turn on go from "fuel to flame" − # Connect your propane tank. − # Make sure the cutoff switch on top of the burner is turned to off. − # Brick up the back and place front brick into the arms on the front of the forge. − # Open up the fuel tank completely. − # Open up the regulator (green knob near the propane tank end of the fuel line). − # Open up the air mix washer to allow more air in. − # Have your light lit and ready to go at the side of the forge (also recommend to stand to the side of the forge when lighting). − # Slowly open the cutoff. − # Once the burner ignites, open the cutoff all the way open. − # Run the forge high for a few minutes to warm it up. Then you can close down the air mix to the point where you have a strong torch going (if you have flames rolling up out of the forge you have choked the torch- open up the air mix a little more) − − * To turn off go from "flame to fuel" − # Turn the cutoff switch to off. − # Close the tank all the way. − # Bleed the line by opening the cutoff switch (be careful as a small flame will pop out the air mix washer) until it is empty. − # Disconnect your tank and plug the hose into the Hot Metal Area tank (the hose must never be left unplugged in). Line 58:
Line 34: + + + + + Line 65:
Line 46: − + − + − |- − |[[user:kuroishi|Doorman Dave]] − |Adrianna McKinley − |- − |[[user:Toba|Eric Stein]] − |Adrianna McKinley − |- − |[[user:PatrickSchless|Patrick Schless]] − |Adrianna McKinley
no edit summary
{{Template:EquipmentPage|owner=Adrianna McKinley
{{Template:EquipmentPage|owner=PS1
|model=Forge
|model=Deulux 2 Burner Knife Makers Forge
|serial=N/A|arrived=??
|serial=N/A
|arrived=No
|doesitwork= yes
|doesitwork= yes
|contact= Adrianna McKinley
|contact= Tom Judge
|where=Hot Metals Area
|where=Hot Metals Area
|certification=yes
|certification=yes
|hackable=no|value=??
|hackable=no
|value=$375
|image = None}}
|image = None}}
== How to get certified ==
== How to get certified ==
Certification process is being reviewed, all users will require recertification.
== Important Information Regarding the Forge ==
== Important Information Regarding the Forge ==
# Try to use the least amount of air mix you can while not choking the torch.
# Try to use the least amount of air mix you can while not choking the torch.
# If you have a question or something seems off - contact the area host or Adrianna.
# If you have a question or something seems off - contact the area host or Adrianna.
== List of recomended Certifiers ==
* Tom Judge
== List of Currently Certified Users ==
== List of Currently Certified Users ==
! Trained By
! Trained By
|-
|-
|Adrianna McKinley
|Tom Judge
|Built Forge
|Area Host
|}
|}