Difference between revisions of "Jointer Grizzly 8 inch"
Jump to navigation
Jump to search
Garynhouse (talk | contribs) (Created page with "{{Template:EquipmentPage |owner = PS1 |certification=yes |hackable = NO |model = Grizzly G0495X |serial = NA |arrived = DEc 2019 |doesitwork = yes |contact = Wood Shop Area H...") |
Garynhouse (talk | contribs) |
||
Line 6: | Line 6: | ||
|serial = NA | |serial = NA | ||
|arrived = DEc 2019 | |arrived = DEc 2019 | ||
− | |doesitwork = | + | |doesitwork = no |
|contact = Wood Shop Area Host | |contact = Wood Shop Area Host | ||
|where = Wood Shop | |where = Wood Shop | ||
Line 15: | Line 15: | ||
== Status == | == Status == | ||
+ | |||
+ | Oot of order due to dust collector sensor blow. part ordered 6/28, to be installed before 7/5/2022 | ||
+ | |||
+ | |||
The danger committee has approved opening the tool for use on Jan 16, 2020. all previously authorized users will be grandfathered | The danger committee has approved opening the tool for use on Jan 16, 2020. all previously authorized users will be grandfathered |
Revision as of 01:01, 1 July 2022
This tool is currently broken, please contact the area host for more information. |
Status
Oot of order due to dust collector sensor blow. part ordered 6/28, to be installed before 7/5/2022
The danger committee has approved opening the tool for use on Jan 16, 2020. all previously authorized users will be grandfathered
This tool requires authorization for use.
Authorized Proctors
This tool requires authorization for use by an authorized proctor. Please contact one of the following to arrange authorization.
Proctor | Contact |
---|---|
Eric Beauchamp — area host | eric @ home-chicago.com |
Ralph Brendler | |
Paul VanLake | |
Michelle DeLeon |
Rules
- Always check your wood for nails or staples. If you're not sure, check the entire piece with the metal detector or a magnet.
- Remove the smallest amount of material possible and feed it at an appropriate speed. More passes are better than fewer. If you don't know how to properly adjust the infeed table, ask for help.
- Always use the vacuum while running the jointer. Otherwise, it will clog with chips.
- If you break something, or damage the tool, contact the area host immediately. Don't let others do more damage to the machine, ruin their work, or hurt themselves by using a broken tool.
- Always vacuum the machine, cutting area, and the table around the machine when you are done.