1,524
edits
Changes
Jump to navigation
Jump to search
Line 6:
Line 6: − + − + Line 16:
Line 16: − Working Beautifully!+ − +
LulzBot AO-100 3D Printer (view source)
Revision as of 22:53, 12 November 2015
, 22:53, 12 November 2015no edit summary
|serial =
|serial =
|arrived = January 2013
|arrived = January 2013
|doesitwork = yes
|doesitwork = no
|contact = Elizabeth
|contact = CNC Area Host
|where = [[CNC]] 2nd Floor
|where = [[CNC]] 2nd Floor
|value = $1725
|value = $1725
== Status ==
== Status ==
As of 11/13/2015 Not working. RD
I had to completely dismantle the extruder. Someone had jammed a ton of orange PLA in there. I even had to drill it out of the plastic part just above the hot end. There was melted material oozing out all kinds of places that it shouldn't be. The actual hot end was packed full of this carbon type stuff (maybe over heated PLA?). I replaced the .5 extrusion tip with the .35 tip. I believe the .5 is permanently damaged due to abusive scraping of the tip. (Scraping the tip will not unclog the head) LG 5/14/2015
Working Beautifully! I had to completely dismantle the extruder. Someone had jammed a ton of orange PLA in there. I even had to drill it out of the plastic part just above the hot end. There was melted material oozing out all kinds of places that it shouldn't be. The actual hot end was packed full of this carbon type stuff (maybe over heated PLA?). I replaced the .5 extrusion tip with the .35 tip. I believe the .5 is permanently damaged due to abusive scraping of the tip. (Scraping the tip will not unclog the head) LG 5/14/2015
Hasn't been used much. Spool-holding bolt is inadequate to hold a spool. Doesn't appear to be extruding ABS even at 230 C. Investigating. RD 5/8/2015
Hasn't been used much. Spool-holding bolt is inadequate to hold a spool. Doesn't appear to be extruding ABS even at 230 C. Investigating. RD 5/8/2015