1,238
edits
Changes
Jump to navigation
Jump to search
mLine 6:
Line 6: − + − + + − Working Beautifully!+ − + Line 39:
Line 40: − + − (Note that you will get better results with settings for .35, we are still trying to nail down wether the extruder got switched at some point and will update this when sure) − + Line 249:
Line 249: − }+ − + + + + + + + + + + + + + + + + + + + + + + +
Rtystgeeke moved page LulzBot A0-100 3D Printer to LulzBot AO-100 3D Printer
|serial =
|serial =
|arrived = January 2013
|arrived = January 2013
|doesitwork = yes
|doesitwork = no
|contact = Elizabeth
|contact = [[CNC|CNC Area Host]]
|where = [[CNC]] 2nd Floor
|where = [[CNC]] 2nd Floor
|value = $1725
|value = $1725
|itemphoto=
|itemphoto=
| image = Lulzbot.jpg
| image = Lulzbot.jpg
|hostarea = CNC
}}
}}
== Status ==
== Status ==
As of 11/13/2015 Not working. RD
I had to completely dismantle the extruder. Someone had jammed a ton of orange PLA in there. I even had to drill it out of the plastic part just above the hot end. There was melted material oozing out all kinds of places that it shouldn't be. The actual hot end was packed full of this carbon type stuff (maybe over heated PLA?). I replaced the .5 extrusion tip with the .35 tip. I believe the .5 is permanently damaged due to abusive scraping of the tip. (Scraping the tip will not unclog the head) LG 5/14/2015
Working Beautifully! I had to completely dismantle the extruder. Someone had jammed a ton of orange PLA in there. I even had to drill it out of the plastic part just above the hot end. There was melted material oozing out all kinds of places that it shouldn't be. The actual hot end was packed full of this carbon type stuff (maybe over heated PLA?). I replaced the .5 extrusion tip with the .35 tip. I believe the .5 is permanently damaged due to abusive scraping of the tip. (Scraping the tip will not unclog the head) LG 5/14/2015
Hasn't been used much. Spool-holding bolt is inadequate to hold a spool. Doesn't appear to be extruding ABS even at 230 C. Investigating. RD 5/8/2015
Hasn't been used much. Spool-holding bolt is inadequate to hold a spool. Doesn't appear to be extruding ABS even at 230 C. Investigating. RD 5/8/2015
=== Suggested Settings ===
=== Suggested Settings ===
Nozzle diameter = 0.5 mm
Nozzle diameter = 0.35 mm
Filament diameter = 3.0 mm
Filament diameter = 3.0 mm
COM port - ?
COM port - 4 (usually)
Data rate = 115200
Data rate = 115200
|Will Garza
|Will Garza
|-
|-
|[[user:kuroishi|Doorman Dave]]
|Elizabeth Koprucki
|-
|[[user:stevenelson|Steve Nelson]]
|Elizabeth Koprucki
|-
|Nem Simeunovic
|Brad Jimenez
|-
|Dafe Hughes
|Brad Jimenez
|-
|Gary Silver
|Brad Jimenez
|-
|Daniel Maziarz
|Brad Jimenez
|-
|Greg Kudlacz
|Brad Jimenez
|-
|Adam Moffatt
|Brad Jimenez
|-
[[Category:Fabrication]]
[[Category:Fabrication]]