Line 23: |
Line 23: |
| ## Replace way wipers. | | ## Replace way wipers. |
| ## Fix y-axis oil lines. | | ## Fix y-axis oil lines. |
| + | ## Reinspect/regrind table and chuck. |
| # Clean Z ways. | | # Clean Z ways. |
| # Replace Z way pleated covers. | | # Replace Z way pleated covers. |
Line 30: |
Line 31: |
| | | |
| == Maintenance == | | == Maintenance == |
− | === Diagnosis === | + | === Current Status === |
| + | The small electromagnetic sine chuck was mounted and ground in to less than a tenth on 2017-03-12. |
| + | |
| + | === Further Diagnosis === |
| After initial repair, diagnosis of further issues will come via a test grind. | | After initial repair, diagnosis of further issues will come via a test grind. |
| | | |
Line 37: |
Line 41: |
| # Five block test can be used as a rough diagnosis. | | # Five block test can be used as a rough diagnosis. |
| | | |
− | === Table Removal === | + | === Procedures === |
| + | ==== Table Removal ==== |
| The table needs to be removed periodically to clean the grinding grit from the ways. | | The table needs to be removed periodically to clean the grinding grit from the ways. |
| | | |
Line 44: |
Line 49: |
| # Remove the nut at the end of the cable on the right side under the table. Fasten a weight to the end of the cable to prevent the cable from unwinding on the capstan. | | # Remove the nut at the end of the cable on the right side under the table. Fasten a weight to the end of the cable to prevent the cable from unwinding on the capstan. |
| | | |
− | === Moving the grinder === | + | ==== Moving the grinder ==== |
| ''Never move the grinder without coordinating with Dean, the owner.'' | | ''Never move the grinder without coordinating with Dean, the owner.'' |
| | | |
| The two table ball cages need to be removed anytime the grinder is moved. This is necessary to prevent the races from Brinelling. To remove the ball cages, disconnect the X axis cable at each end of the table then prop up the ends of the table. | | The two table ball cages need to be removed anytime the grinder is moved. This is necessary to prevent the races from Brinelling. To remove the ball cages, disconnect the X axis cable at each end of the table then prop up the ends of the table. |