Difference between revisions of "Oliver Instrument Die Filer"
Jump to navigation
Jump to search
| (4 intermediate revisions by the same user not shown) | |||
| Line 5: | Line 5: | ||
|arrived=Fall, 2015 | |arrived=Fall, 2015 | ||
|doesitwork=yes | |doesitwork=yes | ||
| − | |contact= | + | |contact=Jim Brink |
|where=Cold Metals, on a bench | |where=Cold Metals, on a bench | ||
| − | |certification= | + | |certification=virial |
|hackable=no | |hackable=no | ||
|value=$500 | |value=$500 | ||
| − | |image= | + | |image=die_Filer.jpg |
|hostarea=Cold Metals | |hostarea=Cold Metals | ||
}} | }} | ||
| Line 29: | Line 29: | ||
|11/6/16 | |11/6/16 | ||
|} | |} | ||
| + | r== Notes == | ||
| − | + | Most files cut on the forword stroke, use a file that cuts on the down stroke with this machine. A source is https://www.falcontool.com/PublicStore/ | |
| − | |||
| − | |||
| − | |||
== Safety == | == Safety == | ||
| − | + | The primary problem with this machine is that the file can grab your work and if your finger is between the work and a hard place it can get smashed. Take light cuts and use the holddown to reduce your risk. | |
[[Category: Cold Metals]] | [[Category: Cold Metals]] | ||
Latest revision as of 23:31, 27 February 2020
 | |
| Owner/Loaner | PS:One |
|---|---|
| Serial Number | 13868 |
| Make/Model | S-4 |
| Arrival Date | Fall, 2015 |
| Usability | yes |
| Contact | Jim Brink |
| Where | Cold Metals, on a bench |
| Authorization Needed | virial |
| Hackable | no |
| Estimated Value | $500 |
| Host Area | Cold Metals |
| Qualified Member | Trained By | |
|---|---|---|
| Dean Anderson | Danger committee | |
| Everett Wilson | Dean Anderson | |
| Jon Komperda | Dean Anderson | 11/6/16 |
r== Notes ==
Most files cut on the forword stroke, use a file that cuts on the down stroke with this machine. A source is https://www.falcontool.com/PublicStore/
Safety
The primary problem with this machine is that the file can grab your work and if your finger is between the work and a hard place it can get smashed. Take light cuts and use the holddown to reduce your risk.