Difference between revisions of "Peristaltic pump controller"
Jump to navigation
Jump to search
(note about clamp tightness) |
m (Robot: Automated text replacement (-doesitwork = WORKING +doesitwork = yes)) |
||
Line 9: | Line 9: | ||
|serial = Unknown | |serial = Unknown | ||
|arrived = November, 2012 | |arrived = November, 2012 | ||
− | |doesitwork = | + | |doesitwork = yes |
|contact = Ryan Pierce | |contact = Ryan Pierce | ||
|where = [[Beer Church]] | |where = [[Beer Church]] |
Revision as of 16:31, 27 October 2013
Owner/Loaner | Ryan Pierce |
---|---|
Serial Number | Unknown |
Make/Model | ? |
Arrival Date | November, 2012 |
Usability | yes |
Contact | Ryan Pierce |
Where | Beer Church |
Authorization Needed | yes |
Hackable | NO |
Estimated Value | $140 |
Host Area | {{{hostarea}}} |
Operation
TODO: write up properly. For now, just hints:
Make sure to screw on the retainer clamp... but not too tight. It's only there to prevent the tubing from walking in the housing, which can cause it to get eaten up. Do'nt clamp it so hard it leaves marks. When you're done using the pump remove the tubing shortly thereafter, leaving it clamped can dent the tubing permanently.
Accessories
- Translucent Tygon Tygoprene Tubing, 1/4" ID, 3/8" OD, 1/16" Wall, 10' Length is the tubing used with this device.
List of Currently Certified Users
Qualified Member | Trained By |
---|---|
Ryan Pierce | Owner |
Eric Stein | Ryan Pierce |
Brittany Zimmerman | Ryan Pierce |