Difference between revisions of "Prusa i3 OctoPrint Server"
Jump to navigation
Jump to search
(operation and other tidbits) |
m (→IP Address) |
||
| (8 intermediate revisions by 3 users not shown) | |||
| Line 16: | Line 16: | ||
== IP Address == | == IP Address == | ||
| − | http://10.100.1. | + | http://10.100.1.203/ is the "middle" Prusa as of December 4, 2018, and has a broken SD card reader. You must use Octoprint to print. |
== Current Status == | == Current Status == | ||
| − | + | Offline. | |
== Authorization == | == Authorization == | ||
| Line 28: | Line 28: | ||
== Operation == | == Operation == | ||
| − | Please see [[ | + | Please see [[Prusa i3 3D printer#Prusa i3 OctoPrint Server]] |
| + | |||
| + | == Recommended Non-Stock Plugins == | ||
| + | |||
| + | * Slicer (1.2.5) | ||
| + | ** A full-blown GUI-based slicer. Rotate and scale model; set layer height and other critical parameters. | ||
== See Also == | == See Also == | ||
| − | [[ | + | * [[Prusa i3 3D printer]] |
| − | [[ | + | * [[Lulzbot Taz3]] |
| − | [[ | + | * [[Taz 3 OctoPrint Server]] |
Latest revision as of 20:02, 6 October 2019
 | |
| Owner/Loaner | PS:One |
|---|---|
| Serial Number | N/A |
| Make/Model | Raspberry Pi 3 |
| Arrival Date | April 2017 |
| Usability | yes |
| Contact | CNC Area Host |
| Where | CNC 1st Floor |
| Authorization Needed | yes |
| Hackable | no |
| Estimated Value | $50 |
| Host Area | CNC |
IP Address
http://10.100.1.203/ is the "middle" Prusa as of December 4, 2018, and has a broken SD card reader. You must use Octoprint to print.
Current Status
Offline.
Authorization
Authorization for this device is determined by authorization for the Prusa i3 3D printer.
Operation
Please see Prusa i3 3D printer#Prusa i3 OctoPrint Server
Recommended Non-Stock Plugins
- Slicer (1.2.5)
- A full-blown GUI-based slicer. Rotate and scale model; set layer height and other critical parameters.