Sherline 8 inch lathe + milling column
From Pumping Station One
File:"Sherline4530.png" | |
Owner/Loaner | PS:One |
---|---|
Make/Model | 4530++ |
Arrival Date | 2017 |
Usability | yes |
Contact | mcclay at popular email service starting with g |
Where | Cold Metals across from the Shapeoko (needs metal-related landmark...) |
Authorization Needed | yes |
Hackable | no |
Host Area | Cold Metals |
larval tool page blather
If the image link is broken: I'm hoping it's just an update thing and will magically start working. The intended image is here. Until a photo in situ happens.
Ralph Brendler very generously donated this "full Sherline clockmaking (metric) setup with all the trimmings (rotating table, change gears, milling column, and lots more)". Apparently in 2017. Time passed. Per area host Jim Brink, I'm "danger committee of one" checking it out and trying to get it online. This is a start at documenting the tool and determining what authorization it may or may not require. Eventually this blathery part should go away.
Inventory
Component | Sherline SKU | Instructions | Note (from memory...) |
---|---|---|---|
8” Lathe with Adjustable Handwheels (Metric) | 4530 | looks complete; morse #1 rusty | |
Lathe Deluxe Vertical Milling Column - Manual (Metric) | 3485 | complete | |
2.5” 3-Jaw Chuck (3/4-16 thread) | 1041 | complete w/extra tommy bars (or a 2nd chuck is missing) | |
Headstock Riser Block Set | 1291 | complete | |
Clockmaker’s Gear-cutting Arbor (7.0mm to #1 Morse taper) | 2094 | missing drawbolt (bolt is trivial but washer is special) | |
Cutters | |||
Crosslide Accessory Plate | 3017 | stiffen crosslide for milling | |
Slitting Saw Holder | 3065 | missing drawbolt (bolt is trivial but washer is special) | |
Slitting Saw[s] [which?] | 730x | ||
Thread Cutting Attachment | 3100 | complete; amazing; zillion parts | |
Mill Vise | 3551 | ||
Manual Rotary Table | 3700 | ||
Right Angle Attachment (for rotary table) | 3701 | complete | |
1/4" Drill Chuck with 2 Arbors | 1072 | conjectural - because have #0 arbor & 1/4in chuck key; if so, missing chuck, #1 arbor and drawbolt | |
more | some Sherline-special T-nuts missing; only need one drawbolt+washer but have zero |