Difference between revisions of "Talk:Laser Cutter Instructions and Workflow"
Jump to navigation
Jump to search
(Question re: auto focus) |
|||
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
− | + | == Configure Laser Settings >> Enable Auto Focus == | |
Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? | Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? | ||
--[[User:Jaypee|Jaypee]] ([[User talk:Jaypee|talk]]) 15:32, 5 November 2013 (CST) | --[[User:Jaypee|Jaypee]] ([[User talk:Jaypee|talk]]) 15:32, 5 November 2013 (CST) | ||
+ | |||
+ | === Auto Focus Induced Head Crash === | ||
+ | |||
+ | I heard some disagreement over auto focus when I was being certified, so it's reasonable that there'd be differing instructions scattered around. Given that the lazor was temporarily out of commission because of an autofocus-induced head crash and Liz is the CNC area host, I went ahead and changed the wording to say "Do '''not''' enable..". [[User:Negativek|Negativek]] ([[User talk:Negativek|talk]]) 15:48, 5 November 2013 (CST) | ||
+ | |||
+ | === Better Cut Quality === | ||
+ | We got better cuts with manual focus over auto focus, enough to make a pretty significant difference. | ||
+ | |||
+ | --[[User:Hef|Hef]] ([[User talk:Hef|talk]]) 09:12, 6 November 2013 (CST) |
Latest revision as of 15:12, 6 November 2013
Configure Laser Settings >> Enable Auto Focus
Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? --Jaypee (talk) 15:32, 5 November 2013 (CST)
Auto Focus Induced Head Crash
I heard some disagreement over auto focus when I was being certified, so it's reasonable that there'd be differing instructions scattered around. Given that the lazor was temporarily out of commission because of an autofocus-induced head crash and Liz is the CNC area host, I went ahead and changed the wording to say "Do not enable..". Negativek (talk) 15:48, 5 November 2013 (CST)
Better Cut Quality
We got better cuts with manual focus over auto focus, enough to make a pretty significant difference.