Domain Admins
5
edits
Changes
From Pumping Station One
Talk:LulzBot AO-100 3D Printer (view source)
Revision as of 01:03, 17 January 2014
, 01:03, 17 January 2014no edit summary
-Keep the speed of gap-filling to a maximum of 20mm/sec.
-Keep the speed of gap-filling to a maximum of 20mm/sec.
-In slicer's "printer" tab, under advanced settings, set the "vibration limit" frequency to 15hz. (This will force movement to slow down for these bone-shaking gap fills if 20mm/s isn't slow enough.)
-In slicer's "printer" tab, under advanced settings, set the "vibration limit" frequency to 15hz. (This will force movement to slow down for these bone-shaking gap fills if 20mm/s isn't slow enough.)
-Check the "enable cooling" box.
-Check the "enable cooling" box.
-Min fan speed 60%, max fan speed 100%. (The fan is unlikely to start if fed <60% power.)
-Min fan speed 60%, max fan speed 100%. (The fan is unlikely to start if fed <60% power.)
-Disable fan for first layer, (so it doesn't spoil adhesion to the bed.)
-Disable fan for first layer, (so it doesn't spoil adhesion to the bed.)
-Enable fan if layer time <60s
-Enable fan if layer time <60s
-Slow printing speed if layer time <30s
-Slow printing speed if layer time <30s
-Minimum printing speed = 3mm/s (This is VERY slow, but that's what it took to get a point on a pyramid, even with the fan at full-blast.)
-Minimum printing speed = 3mm/s (This is VERY slow, but that's what it took to get a point on a pyramid, even with the fan at full-blast.)
-If you need to switch filament, please carefully stow the mounted skein by wrapping it with string, zip ties, (please, no sticky tape,) so it doesn't unravel, and use the built-in filament reel.
-If you need to switch filament, please carefully stow the mounted skein by wrapping it with string, zip ties, (please, no sticky tape,) so it doesn't unravel, and use the built-in filament reel.
-Please mind that the ears of the reel don't bump into the TAZ as they rotate.
-Please mind that the ears of the reel don't bump into the TAZ as they rotate.
-Filament must wind off of the skein from the BOTTOM to feed nicely into the tube, and allow the pull of the extruder to rotate the reel as it should.
-Filament must wind off of the skein from the BOTTOM to feed nicely into the tube, and allow the pull of the extruder to rotate the reel as it should.
-Tighten the wing nut if the reel sags, ears hit the frame of the lulzbot itself when rotating.
-Tighten the wing nut if the reel sags, ears hit the frame of the lulzbot itself when rotating.
