Machine Repaired - Left extruder fan wiring shorted in wire loom causing power cycle when the left thermocouple read 50C+
+
Thermocouples were retaped to ensure electrical isolation from heater block - heater wire can fray and short out on the heater block.
+
5V pin was removed from the end stop cables. This is reversible and protects against internal shorts in the endstop cables. A short could permanently damage the Mightyboard. End stop leds will not work but they still mechanically function as intended.
+
A plastic cover was added to the back of the lcd to prevent accidental damage from grabbing bare conductors. --[[User:Junes|Junes]] ([[User talk:Junes|talk]]) 15:59, 28 October 2014 (CDT)
+
September 22, 2014: Machine reboots when it heats up.
September 22, 2014: Machine reboots when it heats up.