Difference between revisions of "Tormach CNC Plasma Cutter Debugging"
Jump to navigation
Jump to search
Makelemonade (talk | contribs) (Debug courtesy of tachonight/Ron Olson on #hotmetalshop slack) |
(update) |
||
(2 intermediate revisions by 2 users not shown) | |||
Line 3: | Line 3: | ||
Check | Check | ||
− | + | # Is the blue light on the button by the power switch? | |
− | + | # Did you hit the reset button in pathpilot? | |
− | + | # Does the torch move on the Z axis? | |
− | + | # Is the "Machine OK" status light on? | |
− | + | # Did you reference X, Y and Z? | |
+ | |||
+ | Known issue with the MrFluffles post processor as of May 4 2023. Updated August 22, 2023 | ||
+ | The post-processor is adding feed speed, cut height and a dwell command after the M200 command. This overrides the settings of the AutoFS stock picker in Pathpilot. | ||
+ | If you picked the correct tool/settings for your material in Sheetcam this shouldn't be an issue. However, using the same Gcode for different materials will likely lead to less-than-optimal cuts. The extra dwell after the pierce operation (G16) can be eliminated by setting the pierce delay in Sheetcam to zero. |
Latest revision as of 12:34, 22 August 2023
Message: *Button only permitted when machines is in state(s): referenced and idle, g-code program paused, g-code program running*
Check
- Is the blue light on the button by the power switch?
- Did you hit the reset button in pathpilot?
- Does the torch move on the Z axis?
- Is the "Machine OK" status light on?
- Did you reference X, Y and Z?
Known issue with the MrFluffles post processor as of May 4 2023. Updated August 22, 2023 The post-processor is adding feed speed, cut height and a dwell command after the M200 command. This overrides the settings of the AutoFS stock picker in Pathpilot. If you picked the correct tool/settings for your material in Sheetcam this shouldn't be an issue. However, using the same Gcode for different materials will likely lead to less-than-optimal cuts. The extra dwell after the pierce operation (G16) can be eliminated by setting the pierce delay in Sheetcam to zero.