425
edits
Changes
From Pumping Station One
Tormach CNC Plasma Cutter Debugging (view source)
Revision as of 23:08, 8 May 2023
, 23:08, 8 May 2023Known issue with MrFluffles
# Is the "Machine OK" status light on?
# Is the "Machine OK" status light on?
# Did you reference X, Y and Z?
# Did you reference X, Y and Z?
Known issue with MrFluffles as of May 4 2023
The post processor is adding feed speeds and a dwell command after the M200 command. This overrides these settings of the AutoFS stock picker in Pathpilot.
If you picked the correct tool for your material in Sheetcam this shouldn't be an issue.
However, using the same Gcode for different materials will likely lead to less-than-optimal cuts.
