Tormach CNC Plasma Cutter Debugging
Revision as of 19:34, 2 May 2023 by Makelemonade (talk | contribs) (Debug courtesy of tachonight/Ron Olson on #hotmetalshop slack)
Message: *Button only permitted when machines is in state(s): referenced and idle, g-code program paused, g-code program running*
Check 1. Is the blue light on the button by the power switch? 2. Did you hit the reset button in pathpilot? 3. Does the torch move on the Z axis? 4. Is the "Machine OK" status light on? 5. Did you reference X, Y and Z?