Tormach CNC Plasma Cutter Debugging

From Pumping Station One
Revision as of 23:08, 8 May 2023 by Mskilton (talk | contribs) (Known issue with MrFluffles)
Jump to navigation Jump to search

Message: *Button only permitted when machines is in state(s): referenced and idle, g-code program paused, g-code program running*

Check

  1. Is the blue light on the button by the power switch?
  2. Did you hit the reset button in pathpilot?
  3. Does the torch move on the Z axis?
  4. Is the "Machine OK" status light on?
  5. Did you reference X, Y and Z?

Known issue with MrFluffles as of May 4 2023 The post processor is adding feed speeds and a dwell command after the M200 command. This overrides these settings of the AutoFS stock picker in Pathpilot. If you picked the correct tool for your material in Sheetcam this shouldn't be an issue. However, using the same Gcode for different materials will likely lead to less-than-optimal cuts.

Retrieved from "https://ps1.mywikis.wiki/w/index.php?title=Tormach_CNC_Plasma_Cutter_Debugging&oldid=46147"