1,524
edits
Changes
Jump to navigation
Jump to search
Line 64:
Line 64: + + + + + +
Universal PLS6.150D 150W Laser Engraver (view source)
Revision as of 23:51, 24 July 2018
, 23:51, 24 July 2018→Procedures
=== Exhaust ===
=== Exhaust ===
* Turn on the Exhaust Fan by flipping the switch on the gray box to the left of the Boss Laser.
* Turn on the Exhaust Fan by flipping the switch on the gray box to the left of the Boss Laser.
=== Powering On Machine ===
=== Powering On Machine ===
* Turn on the Power Switch and let the machine complete the entire boot up cycle, approximately 1-2 minutes.
* Turn on the Power Switch and let the machine complete the entire boot up cycle, approximately 1-2 minutes.
== Running your job ==
*Use the printer driver and Universal Control Panel (UCP) to send data to the laser.
*The printer driver is discussed from page 39-57 of the manual, and on page 58-62, the UCP is explained.
*https://wiki.pumpingstationone.org/images/Universal_PLS6.150D_user_guide.pdf
=== Powering Off Machine ===
=== Powering Off Machine ===