Line 13: |
Line 13: |
| | | |
| I suggest we do the following: | | I suggest we do the following: |
− | 1) Replace the two filters in the Clearvue cyclone filter stack. $165 each from Wynn.
| + | # Replace the two filters in the Clearvue cyclone filter stack. $165 each from Wynn. |
− | 2) Enclose the collector rack with an acoustic barrier. Add a muffler to the exhaust.
| + | # Enclose the collector rack with an acoustic barrier. Add a muffler to the exhaust. |
− | 3) Automate the blast gates. When a machine is turned on, the blast gate (valve in the duct) will open and stay open for a few seconds.
| + | # Automate the blast gates. When a machine is turned on, the blast gate (valve in the duct) will open and stay open for a few seconds. |
− | 4) Replace the fine dust bin below the filter stack with a wood bin tall enough to support the stack without the orange bucket. The goals are to add dust holding capacity and support the stack more securely.
| + | # Replace the fine dust bin below the filter stack with a wood bin tall enough to support the stack without the orange bucket. The goals are to add dust holding capacity and support the stack more securely. |
− | 5) Add more equipment to the collection system. The new bandsaw, jointer, router table and sanders should be added.
| + | # Add more equipment to the collection system. The new bandsaw, jointer, router table and sanders should be added. |
− | 6) Add more dust collection capacity. The Clearvue system can support 2 or sometimes 3 simultaneously running machines. When the shop is busy, we exceed this.
| + | # Add more dust collection capacity. The Clearvue system can support 2 or sometimes 3 simultaneously running machines. When the shop is busy, we exceed this. |
− | 7) Add overhead dust collection to the sawstop. This was in the original dust collection vote, but we didn't get it due to a long lead time on the part. http://www.thesharkguard.com/sharkdc.php
| + | # Add overhead dust collection to the sawstop. This was in the original dust collection vote, but we didn't get it due to a long lead time on the part. http://www.thesharkguard.com/sharkdc.php |
− | 8) Flow sensor to the duct and pressure sensors before and after the cyclone.
| + | # Flow sensor to the duct and pressure sensors before and after the cyclone. |
− | 9) Bin level sensors for the cyclone bin and the filter stack bin.
| + | # Bin level sensors for the cyclone bin and the filter stack bin. |
− | 10) Enclose the filter stack so we can apply a burst of pressure to clean the filter.
| + | # Enclose the filter stack so we can apply a burst of pressure to clean the filter. |
− | 11) Better filter/small cyclone for the Jet dust collector.
| + | # Better filter/small cyclone for the Jet dust collector. |
| | | |
| == Language == | | == Language == |