2
edits
Changes
From Pumping Station One
→Suggested Settings
Data rate = 115200
Data rate = 115200
Temperature (degrees C)
Extruder: 230
Bed: 110
Lulzbot's slic3r config has the infill density set at 0.75. Resulting prints are very sturdy as a result, but the filament consumption and print time go up because of this. It is recommended to turn it down to 0.15 or 0.25, and to increase the number of infill shells. Doing so should have a similar surface quality, but produce a print with significantly less mass.
Lulzbot's slic3r config has the infill density set at 0.75. Resulting prints are very sturdy as a result, but the filament consumption and print time go up because of this. It is recommended to turn it down to 0.15 or 0.25, and to increase the number of infill shells. Doing so should have a similar surface quality, but produce a print with significantly less mass.
