Difference between revisions of "Talk:BOSS LS-3655 150w Laser Engraver"

Revision as of 15:21, 5 March 2017

Q: Test cuts accumulating ... is there a place where best practices notes are being collected? - Ray

A: You can post best practice notes here and then we can go over them as a group Skynaya (talk) 09:03, 5 March 2017 (CST)

It's really easy to catch things on fire! This is a given. Skynaya (talk) 09:09, 5 March 2017 (CST)

Material	Thickness	Mode	Min Power	Max Power	Speed MM/s	Passes	Air Assist	Notes	Tested By
Sample Material	1/4 inch	Scan	0%	0%	5mm	1	Yes	Insert informative notes here	Insert your signature
x	x	x	x	x	x	x	x	x	x
Acrylic	1/4th inch	Cut	29%	29%	12mm	2	Yes	Required two cuts, increase power or slow speed	Skynaya (talk) 09:19, 5 March 2017 (CST)
Acrylic	1/4th inch	Scan	29%	29%	300mm	1	Yes	Fairly good engrave, lots of acrylic dust. With the power of this laser, might be better to have protective film on for engraving and cutting.	Skynaya (talk) 09:21, 5 March 2017 (CST)

@@ Line 34: / Line 34: @@
 |Insert your signature
 |-
+|x
 |x
 |x
@@ Line 54: / Line 55: @@
 |Required two cuts, increase power or slow speed
 |[[User:Skynaya|Skynaya]] ([[User talk:Skynaya|talk]]) 09:19, 5 March 2017 (CST)
+|-
+|Acrylic
+|1/4th inch
+|Scan
+|29%
+|29%
+|300mm
+|1
+|Yes
+|Fairly good engrave, lots of acrylic dust. With the power of this laser, might be better to have protective film on for engraving and cutting.
+|[[User:Skynaya|Skynaya]] ([[User talk:Skynaya|talk]]) 09:21, 5 March 2017 (CST)
 |-}