Grizzly 6" jointer
From Pumping Station One
Revision as of 16:44, 29 July 2015 by Rdoeksen (talk | contribs) (→List of Currently Certified Users)
This tool is currently broken, please contact the area host for more information. |
Rules
- Always check your wood for nails or staples. If you're not sure, check the entire piece with the metal detector or a magnet.
- Remove the smallest amount of material possible and feed it at an appropriate speed. More passes are better than fewer. If you don't know how to properly adjust the infeed table, ask for help.
- Always use the vacuum while running the jointer. Otherwise, it will clog with chips.
- If you break something, or damage the tool, contact the area host immediately. Don't let others do more damage to the machine, ruin their work, or hurt themselves by using a broken tool.
- Always vacuum the machine, cutting area, and the table around the machine when you are done.
Documentation
Authorized Proctors
Matt Triano |
List of Currently Certified Users
Qualified Member | Trained By |
---|---|
Matt Triano | Owner |
Jason Shanfield | Matt Triano |
Sam Drazin | Matt Triano |
Eric Beauchamp | Matt Triano |
Ryan Pierce | Matt Triano |
Pete Noverini | Matt Triano |
Mike Coriale | Matt Triano |
Will Garza | Matt Triano |
Chris Kleehammer | Jason Shanfield |
Trey Elliott | Jason Shanfield |
Nik Brink | Jason Shanfield |
Bradley Topol | Matt Triano |
Mike Jones | Matt Triano |
Ray Doeksen | Jason Shanfield |
Hunter Koerner | Eric Beauchamp |