Difference between revisions of "Shop Fox 8" Plate Shear"
Jump to navigation
Jump to search
m (Robot: Automated text replacement (-doesitwork = Working +doesitwork = yes)) |
|||
Line 2: | Line 2: | ||
| owner = Michael Skilton | | owner = Michael Skilton | ||
| model = M1040 | | model = M1040 | ||
− | | doesitwork = | + | | doesitwork = yes |
| contact = Michael Skilton | | contact = Michael Skilton | ||
| where = Machine Shop | | where = Machine Shop |
Revision as of 16:44, 27 October 2013
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.