Jalenko Burn-out Furnace

From Pumping Station One
Jump to navigation Jump to search

Jalenko Burn-out Furnace
Owner/Loaner PS:One
Serial Number ?
Make/Model Jalenko Model IFC
Arrival Date 2013
Usability yes
Contact Eric Stein
Where Removed
Authorization Needed no
Hackable no
Estimated Value $70
Host Area Hot Metals

Jalenko Burn-out Furnace Area: Hot Metals https://wiki.pumpingstationone.org/wiki/Jalenko_Burn-out_Furnace


  • Ensure that burn out tray is in place
  • Plug in
  • Turn Dial clockwise past off
  • Select desired temperature (0 is hottest, 10 is coldest)
Setting Approximate Temperature (deg C)
10 200
9.2 370
6.2 750
6.8 700


  • This thing holds a temperature pretty well, once you get it dialed in it stays rock steady
  • There is no temperature probe at the moment. There is a hole on the back which angles upward and is ~6-7mm diameter.
  • Maximum temperature has not be assessed. The above table has most useful values for casting with Kerr Satin Cast 20 investment in our size flasks.


  • Make some graphs of how fast it will typically heat up over time given different settings and flasks.
  • Get new ceramic drip tray (current one is cracked)
  • Put the PS1 equipment label on a hard tag and wire it to the power cord (affixing it to the equipment itself is unfeasible, it gets too hot.
    • This would be cool to do with anodized aluminum in the laser --Dbever (talk) 22:19, 11 June 2014 (UTC)
  • Hack together some type of replacement guage
    • The old guage was connected to some type of ceramic temperature probe of unknown variety and was disintegrating. If we can get the same type probe it may work again, but more useful would be a digital read out