ShapeOko2 CNC Router
This tool is currently broken, please contact the area host for more information. |
Owner/Loaner | PS:One |
---|---|
Serial Number | 5549 |
Make/Model | ShapeOko 2 "The Works" version |
Arrival Date | 2014 |
Usability | no |
Contact | CNC Area Host |
Where | CNC table in the shop |
Authorization Needed | yes |
Hackable | no |
Estimated Value | $1000 |
Host Area | CNC |
Status
Components are all there, but the unit needs some work before becoming fully operational. See "Maintenance" notes below.
Authorization
Preflight Checklist
Known Issues
Modifications
Maintenance
9.8.2016 - Danny Blanchard: Drag chain bracket installed, new lock washers installed (machine can now travel freely until it crashes... :). GRBL shield and Arduino Uno were removed and bent/disconnected pins repaired (likely due to rough handling?). E-stop switch backing nut tightened. Machine ran fine on Easel and with GRBL Controller.
9.7.2016 - Danny Blanchard: Machine cleaned, belts tensioned, power supplies temporarily mounted to wall, wires organized and secured with zip ties. Spindle control and E-Stops tested, both working.
Items that still need work:
1. Waste board repaired or replaced. Entire board is unsupported in the middle, causing it to sag. Also, one stud has pulled up a volcano-like mountain in one part of the waste board, and needs to be milled down. Recommend getting two $7 20mmx20mmx300mm extrusions (from Inventables or elsewhere) and T-nuts to support it in the middle (this is a common upgrade for this particular machine).
2. Bearing blocks on all axis need to be tuned. Some are not making contact, and gantry is not square to waste board.
3. Spindle PWM, both power supplies, and perhaps the GRBLShield should be mounted in a compact, fan-cooled enclosure. I'd love said enclosure to be part of a full machine enclosure that incorporates noise suppression, interior lighting, and dust collection.
4. Install Homing and limit switches, and connect to GRBLShield. This should prevent some crashes.
5. General wiring clean-up and sheathing: some connectors have bare leads exposed, and I'd love to clean up the build by sheathing many of the wires.
6. Label axis, electrical components, etc with a label-maker for ease of understanding.
Documentation
ShapeOko 2 wiki for assembly, use, and source files.
Certified Users
qualified member | trained by |
---|---|
Elizabeth | Herself as she built it |
Clarence Risher | Elizabeth |
Ron Olson | Elizabeth |
Darold Higa | Elizabeth |
Aaron Mintz | Elizabeth |
Michael Solheim | Elizabeth |
Eric Beauchamp | Elizabeth |
Roger Moore | Elizabeth |
Kyle Bieneman | Elizabeth |
Andrew Camardella | Elizabeth |
Todd Allen | Elizabeth |
Sam Reicks | Andrew Camardella |
Ray Doeksen | Sevin Strauss |
Leon Grossman | Sevin Strauss |
Ryan Taylor | Leon Grossman |
Simon Pyle | Sevin Strauss |
Ralph Brendler | Arturo Duarte |
Jeremy fay | Arturo Duarte |